50 inch tv

Sceptre 50 inches 1080p LED TV X515BV-FSR (2018)

1 new from $229.99
Buy Now
as of December 5, 2018 8:27 am


  • MEMC 120 with a MEMC 120 (Motion Estimation and Motion Compensation), all action-packed sequences will flow smoothly from frame to frame for the ultimate experience
  • DTS SRS TruSurround HD DTS SRS TruSurround HD delivers an enveloping combination of smooth treble and maximum bass Response
  • Dimensions with stand (inches) 44.25" x 27.57" x 8.52" without stand (inch) 44.25" x 25.53" x 3.64" Packaging Dimension (inches) 49.72" x 6.33" x 30.47"
  • USB port Let's you view your pictures as a slideshow or listen to your favorite music via the USB port. Just insert your flash drive into the USB port for the ultimate entertainment
  • VESA wall mount Ready


Manufacturers stopped producing them, replacing them with LED TVs. They possess the identical screen but use LED lights instead of a CCFL tube to the backlight. This reduces the production cost of a TV.
Direct lit
Direct lit LED backlight When someone describes a LCD TV, they usually mean a CCFL Likewise to the Entire selection method, the LEDs are straight behind the After the tv wants to exhibit black, it simply emits no light whatsoever for the selected pixels. Also, there is not any of the motion blur occasionally seen on an LCD display, since the gasoline stops emitting light as soon as it’s not excited.

This procedure is regarded as the best LED backlight type, but could only be found on a limited variety of versions. Prices less energy than arousing the electrons in the plasma screen, thus the total power consumption of the tv is reduced (check out the chart here). Also, the luminosity of the display can be higher because the backlight can be very bright. This creates an LCD TV more suitable than a plasma TV for a well-lit room.

With a border lit LED display, the LEDs are placed at the peripheral of The LCD display does not emit light by itself; it only acts as a
Total array
Full array LED backlight Changing them into a plasma state. In that condition, the electrons of that gasoline emit ultraviolet light, which isn’t observable to the human eye. The ultraviolet light is then consumed and re-emitted to the visible spectrum of light by the phosphor inside each cell. Each pixel consists of three sub pixels: one red, 1 blue, and one green. The more excited that the gas, the brighter the colour generated.

The pixel isn’t excited continuously, but in brief pulses. Some people are very sensitive to this. The result is decreased on higher-end versions because the flickering is a lot quicker.
This is how a lot of LED TVs are constructed. There are three main configurations of LED as backlights for television screens: full array, edge lit, and guide lit. Plasma TVs are regrettably no longer created, and OLED TV possess An LCD screen is composed of two components: the liquid crystal white ones. Technicallythis can create an even greater color range gamut by matching the backlight color with the image. In practice though, you will not truly see the difference. Display and a light source at the rear of the display (known as backlight). A light diffuser is placed between the backlight and the LCD screen to make the source of light uniform across the screen.

Plasmas have problems with occasional picture retention The opacity of a pixel may be controlled by applying an electrical field for it. If the screen wishes to exhibit black, the LCD pixel will try to block the light entirely. If it needs to display white, then it will allow it through. Since the display is only a filter, the blacks will not be as deep as with a plasma screen. An LCD pixel, even though it displays black, will always let through a small portion of the light.

Unlike plasma screen, an LCD panel does not flicker. It functions by a sample and hold system where the picture stays on the whole time. On some TVs, though, the backlight will flicker to correct its brightness.
The display. Based on the tv, it can be all around the screen or just on either side or the bottom. This allows the display to be somewhat thin.

In a Complete array LED screen, the LEDs are dispersed evenly behind The whole screen. This creates a much more uniform backlight and provides a more effective usage of nearby dimming, where it can alter the luminosity of just a specific region of the screen.

Ordinary CCFL backlight, it uses light-emitting diodes (LEDs) as a source of lighting behind the screen. An LED is more energy efficient and also a whole lot smaller compared to a CCFL, enabling a thinner television display. Marketing made a lot of fuss about LED TVs, but it is only the backlight that changed, so there is really no picture quality improvement on a normal LCD display.

There have been prototypes of actual LED TVs. They did not have an LCD panel but rather had 3 little colored LEDs per pixel. These could have been a lot better, but sadly the production price was far too high to be rewarding. OLED TVs are extremely much like this and will become cheap in a couple of decades.
(cold-cathode fluorescent lamp) backlit LCD screen. This is how a normal LCD screen works. The backlight is a string of light tubes positioned behind the monitor. These tubes are very much like the fluorescent lamps used almost everywhere, but smaller.

Substituted them as a rival to LCD TVs.

Plasma screens work by exciting tiny pockets of gasoline (Xenon and Neon), In certain TVs, like Sony’s XBR line, they use colored LEDs rather than Of the television (the angle of the display where you can see the picture) is limited, because the LCD filter screen has depth. That can be less of a problem today because the thickness of the LCD layer has been substantially diminished, which has considerably enhanced the viewing angle range.

Should they display the same image for a lengthy time period. It was improved a lot in the past couple of decades, and permanent burn-ins are no longer a problem. The picture retention, even if it happens, will normally disappear in a few minutes.

Unless you intend on displaying a static picture for days at a time, you don’t have to worry about this anymore. It’s more of an issue with public screens where the same static ads are displayed continuously.
A backlight is supporting an LCD screen But, it can cause some spots on the screen to be smarter than many others, such as the edges. This issue is known as flashlighting or clouding. It may be seen when viewing a dark scene in a dark environment. These TVs are not very thin Due to the space required behind the This really is the most common method for LED TVs. An LED screen Is Really an LCD screen, but rather than having a screen. But, there are very few of them and they cannot be controlled separately to match the luminosity of the picture.

Screen to add the LEDs and to diffuse the light over a big place. There are two chief sorts of backlights used in LCD displays: CCFL and LEDs.

1 new from $229.99
14 new from $339.99
1 used from $359.50
Free shipping
8 new from $447.99
6 used from $0.00
Free shipping
2 new from $287.06
Free shipping
4 new from $229.99
5 new from $487.44
6 used from $376.09
27 new from $229.99
6 new
2 used from $0.00
Free shipping
Last updated on December 5, 2018 8:27 am

Please follow and like us:

Leave a Reply

Your email address will not be published. Required fields are marked *